Improve the success rate of a splicing (4) Each splicing parts inspectionnull

According to empirical data, cycle splicing ratio should be controlled within 1.3, or it will seriously affect the production efficiency. Production should pay attention to the following points: Negative pressure gauge can not be less than 4 000 Pa, if lower than this value, the need to stop cleaning (under normal circumstances, a variety of lint easily lead to clogging); (To the air splicer to send the yarn nozzle) with or without clogging phenomenon, if any should be ruled out; check the yarn picks nozzle cleaning, the activities of the top of the suction nozzle to be cleaned (with a damp cloth or cotton yarn); Check whether the internal surface of the large yarn picker is smooth and whether there is any accumulated dirt or not, which can be cleaned with a test tube brush. When spinning a fine yarn or a chemical fiber yarn with a large content, the increase in the end of a large nozzle may be considered Tip rate steel comb.

( All of our winders are suitable for assembly air splicer, Https://www.windermachine.com/odm-oem-service

For the yarn electric clear https://www.windermachine.com/odm-oem-service please contact us. )

更多文章 MORE+

Gonghong Textile Machinery Winder Manufacturer

Over the past 20 years, we have taken technological innovation as our life and strived for survival by quality.

+00 86 135-1651-0653

beckykwok@windermachine.com

Building B8, Luocun New Light Source Base, Nanhai District, Foshan, Guangdong, China

Cancel

添加微信好友，详细了解产品

使用企业微信
“扫一扫”加入群聊

复制成功

添加微信好友，详细了解产品

我知道了

Improve the success rate of a splicing (4) Each splicing parts inspection

Follow Us